The problem of CNC woodworking engraving machine tool itself: a certain part of the machine tool has problems or looseness, and there are impurities in the appearance, etc.; the CNC woodworking engraving machine manufacturers find that the coupling is loose and broken, and will be misaligned; If the screw is not cleaned for a long time, it will also be misplaced; if the machine tool line of the CNC woodworking machine is broken, it will also be misplaced. CNC woodworking engraving machine manufacturers found that each part of the connection control line is in poor contact (control line transmission line). Solution: Remove all connections and reinstall.
CNC woodworking engraving machine manufacturers tailor-made production of CNC engraving machine, laser engraving machine, wood engraving machine, stone engraving machine, advertising engraving machine, mold engraving machine, three-dimensional engraving machine and other equipment. CNC woodworking engraving machine is an important production tool for wood processing, and production capacity is very important. CNC woodworking engraving machine will present various misalignment problems during the carving process, such as left and right misalignment, up and down dislocation, x-axis dislocation, z-axis dislocation, etc. What is the reason for the Zhengzhou woodworking engraving machine to be misplaced?
The problem of the CNC woodworking engraving machine driver: the layout inside the drive itself or the problem of the electronic original equipment will also form a misalignment phenomenon, this reason is the most; if the number of renderings is not much, and the speed is reduced a little, sometimes it can be carved normally, which indicates the driver It hasn't completely broken yet; if it is scratched at the beginning, it means the drive is completely broken. Solution: Repair the drive or replace the drive.
CNC woodworking engraving machine manufacturers view the correct way of carving software; CNC woodworking engraving machine manufacturers to see the gap between the CNC woodworking engraving machine screw and the tightening screw of the polished rod; check whether the software parameters are set correctly; view the ground wire Is it connected?
CNC woodworking engraving machine manufacturers computer is not a virus or may not be compatible with other interference, usually advocate no need to brand machine, simply assemble the chassis; water-cooled spindle motor front upper coupling is not loose damage, you can view the hand tighten or replace;
Is there any contact failure in the line of the CNC woodworking engraving machine to the machine control box? The voltage problem: the CNC wood engraving machine requires a large amount of power during operation. If the voltage is too low, the power supply to the driver is lacking, and the power is not up. When it is reached, it will form a dislocation phenomenon. This situation is usually caused by the y-axis misalignment. This phenomenon may be caused by the external voltage, and some people may use high-power equipment such as electric welding on the same line. Solution: Install a 5000 watt regulated power supply, but the error size of this regulated power supply should not exceed 5%, preferably within 3%. Problems with the interface board, main board, and adapter board: If the interface board, the main board, and the adapter board are broken, the woodworking engraving machine does not move in one direction or three axes during the operation, forming a misplaced position. Problems with the spindle motor: If the stepper motor or the servo motor is not working, the whole machine does not move in a certain direction, and the screw is not turned by the hand.
