Woodworking engraving machine should always clean the impurities during normal use. Otherwise, the engraving machine will have a lot of dust and impurities inside the lead screw, guide rail and bearing inside the long-term operation, which will cause the screw to rotate. The bearing rotation resistance is large, and the engraving speed will appear slightly. When it is faster, there will be a phenomenon of lost step.
The company gives you some suggestions for your reference:
Choose a lubricant: a mixture of oil and butter, not too thick. Lubrication step: Before the lubrication, remove the impurities on the lead screw, the wire on the guide rail and the bearing. If there is any gasoline that can't be removed, clean it and then inject the lubricant and then gradually increase the speed to carry it away.
1. The continuous operation time of the woodworking engraving machine is less than 10 hours per day to ensure the cleaning of the cooling water and the normal operation of the water pump. The water-cooled spindle motor must not be dehydrated, and the cooling water should be replaced regularly to prevent the water temperature from being too high. As the use of engraving machines has become more widespread, have we ever thought about some routine maintenance when using engraving machines?
2, woodworking engraving machine after each use of the machine, should pay attention to cleaning, be sure to clean the dust on the platform and transmission system, regular (weekly) lubrication of the transmission system (XYZ three-axis).
3. If the woodworking engraving machine is not used for a long time, it should be refueled regularly (weekly) to ensure the flexibility of the transmission system.
4, woodworking engraving machine regularly (according to the use of conditions) to clean the dust inside the electrical box, check the terminal screw is loose, to ensure safe and reliable use of the circuit. At the shaft, the thrust bearing of the shroud, the lead screw, the guide rail and the bottom of the bearing should be opened at a glance. The work done at this time is: lubrication of the mixed oil in the up and down operation.
5, woodworking engraving machine regularly (according to the use of conditions) check whether the screws of the various parts of the machine are loose. Lubrication cycle: Depending on the working environment and machine working time, it is generally cleaned up after work every day. Refueling every part of the month and lubricating at high speed. The shaft needs to be removed from the front and rear screws, and a shield is lifted. Note: The line on the left side of the side panel should be loosened and then lifted on the right side to fully open the mixed oil to the rail, the lead screw, the bearing and the right screw head. Thrust bearing. When lubricating the three shafts, the inner hexagonal screws on the coupling between the motor shaft and the screw head can be tightened by the inner hexagonal wrench to prevent the three shafts from being misaligned due to loose mechanical parts. Other maintenance part of the water pump, the cutting spindle, the two are mutual, it is necessary to often replace the circulating water to the engraving machine to keep the water and water temperature to block the water outlet of the water pump or the water-cooled cutting spindle to operate at high temperature to cause component damage.
